Self Adhesive Vinyl Floor Tiles – Removing the carpet from a concrete floor does not always leave the floor clear and clean for installing vinyl tiles. To prepare the flooring for tiles totally first you have to remove the adhesive of high resistance used in the installation of the carpet. Once the adhesive is removed from the placement of the tiles you can proceed.
Using self-adhesive vinyl tiles reduces nature’s clutter and requires a lot of time to install the self adhesive vinyl floor tiles, giving you the new look you want for a room in a matter of hours. Scrape adhesive carpet remaining on your concrete floor after removing the carpet using a long handle bottom scraper. Place the blade edge of the scraper against the concrete at a 45-degree angle above the adhesive cover. Press firmly on the sheet, pushing through the adhesive to the concrete below. Push the blade along the surface, being careful not to cut the concrete, scraping the adhesive.
Sweep the adhesive and place in a plastic bag for disposal. Remove any adhesive residue with alcohol. Dip a sponge into the alcohol and moisten the surface of the self adhesive vinyl floor tiles. Use a cleaning brush when necessary to remove any difficult to clean dirt deposits. Rinse the surface with water and then let it dry overnight before placing the vinyl tile. Place a vinyl tile in the center of the room, surrounded by one of the 90-degree angles.