Style Barn Sliding Door Hardware

Contemporary Barn Sliding Door Hardware

Barn sliding door hardware – Doors barn style have a charm timeless, are linked to an old red barn, a shed or back door. A door of this type is simple in its design, but is quite strong. If you like the rural and functional appearance of a door type barn, build yourself your. Use reclaimed wood from an old barn or any other type that matches the aesthetics of your home. A barn sliding door hardware style will give the entrance of your home or building a warm air and at the same time picturesque.

Measure the length and width of your door. Subtract 0.6 cm wide and 1.2 cm long to allow the door to open properly. Cut the sheet 15 cm x 2.5 cm in two pieces having the width of the door. They are the upper and lower parts of the door. Place the two parts cut in the ground, spaced as to fit the door. Measure the distance between the plates from above and below. Use this length to cut the three tablets of 2.5 cm x 30.5 cm so that they fit between the upper and lower parts.

Put the plates of 2.5 cm x 30.5 cm side by side between the top and the bottom installing on barn sliding door hardware. If they are wider than the upper and lower parts, you will need to reduce the width of each equally.

You May Also Like

Leave a Reply